Separate slip rings BLS Series
Sometimes a self-contained “capsule” slip ring is not practical due to system
size constraints or cost limitations. We can provide the slip ring (rotor) and brush
block (stator) as separate components to be mated by the customer in their system.
It can be used for routing hydraulic lines and pneumatic lines, it is especially fit
for minute and precise instruments , at the same time customization is available for
your special need.
Specification |
www.chineseslipring.com |
Basic Parameters: |
|
Ring ring |
Number1-10 |
Option
● Operating speed
● Circuits
● Signal, power combined
●Current &Voltage
● Lead wire length
●Lead wire exit direction
● Protection class
● Connector |
Operating Speed |
0-500rpm |
Working Temperature |
-40℃~ +80℃ |
Working Humidity |
60%RH or higher |
Electrical: |
Voltage Rating |
240VAC/DC |
Current Rating |
1A-3A |
Dielectric Strength |
≥500 VAC@50Hz between per circuit |
Insulation Resistance |
500 MΩ@500VDC |
Electronic Noise |
≤7mΩ |
Mechanical: |
Contact Material |
Gold on Goldl |
Wire Size |
AWG28 or AWG30 UL certification |
Cable length |
Standard 200mm (7.874inch) |
Caps Materia |
Plastic or metal |
Moment |
≤ 0.15 g · m (only parameter to consider) |
Protection Grade |
IP54 or higher |
Others: |
|